Thanks for this being one of many tips from you! I love it when you guys share this stuff! Greg Joseph Garrett wrote: > Greg, > No. I install the shims with epoxy. The epoxy I use is from the Lord > Corporation, Erie PA, # E-552 A & B. It has a color and will stick to > vertical surfaces. I also use it to bed pin blocks and filling the cracks in > my shop cement floor. :-) > I mask the edges of the cracks, insert shims with epoxy and weigh down with > coffee cans full of tuning pins, (Plastic top on the bottom). When the epoxy > is half set, I remove the masking tape. This epoxy fills well, sands nice > and blends with the soundboard. I've been using this epoxy for many years. > It has a 2 year shelf life. I discovered it when I was working with Del. > (Actually, Del was the discoverer.) From time to time, I've tried other > types, but like this the best. > Regards, > Joe Garrett, R.P.T. > ----- Original Message ----- > From: "Greg Newell" <gnewell@ameritech.net> > To: <pianotech@ptg.org> > Sent: Wednesday, May 02, 2001 9:19 PM > Subject: Re: Soundboard shims via Spurlok method > > > 4/30/2001 7:37:12 AM, "Joseph Garrett" <joegarrett@earthlink.net> wrote: > > Joe, > > Thank you for the post. I have been contemplating using shims where it can > easily be seen and epoxy everywhere else. > > Is this similar to what you are doing? > > > > Greg > > > > > > >Greg, > > >I use a combination of shims and epoxy. Cosmetically ok and structurally > > >sound. > > >regards, > > >Joe Garrett > > >----- Original Message ----- > > >From: "Greg Newell" <gnewell@ameritech.net> > > >To: "Pianotech forum" <pianotech@ptg.org>; "Master Piano Tech" > > ><mpt@talklist.com>; "College and University Technicians" <caut@ptg.org> > > >Sent: Monday, April 30, 2001 12:58 PM > > >Subject: Soundboard shims via Spurlok method > > > > > Greg Newell > > Greg's Piano Forté > > 12970 Harlon Ave. > > Lakewood, Ohio 44107 > > 216-226-3791 > > mailto:gnewell@ameritech.net > > > > -- Greg Newell Greg's Piano Forté 12970 Harlon Ave. Lakewood, Ohio 44107 216-226-3791 mailto:gnewell@ameritech.net
This PTG archive page provided courtesy of Moy Piano Service, LLC