FYI, the tip that came with my Danair Palm Nailer has the following specs. Maximum Nail Head Diameter: 21/64" Size Penny Nail: 3-8 Model Number: RN 16-8 I find that it would be OK if the tip were a bit smaller - but it is just fine as-is. It also has a spring-loaded collar that extends down below the hammering surface to keep the hammering surface on top of the nail/tuning pin. Terry Farrell Piano Tuning & Service Tampa, Florida mfarrel2@tampabay.rr.com ----- Original Message ----- From: "Joseph Garrett" <joegarrett@earthlink.net> To: <pianotech@ptg.org> Sent: Monday, May 07, 2001 7:19 PM Subject: Re: Air Hammer > Carl, > It came with 3 "tips". 1."finish nail": @.2000" ID 2. "Magnetic tip": > @.4500", which is ok diameter, but don't want magnetized tuning pins! 3. > "Standard tip: .5000", which is too darned big! > Could you tell me the size of the "tip" you use? > Regards, > Joe Garrett > ----- Original Message ----- > From: "Carl Meyer" <cmpiano@home.com> > To: <pianotech@ptg.org> > Sent: Monday, May 07, 2001 2:25 PM > Subject: Re: Air Hammer > > > > > > Joe! Just what exactly is the ID of the tip you have on your air hammer? > > > > Carl Meyer > > > > ----- Original Message ----- > > From: Joseph Garrett <joegarrett@earthlink.net> > > To: <pianotech@ptg.org> > > Sent: Sunday, May 06, 2001 11:32 PM > > Subject: Re: Air Hammer > > > > > > > Bought one of these at that price. Still trying to figure out how it > > works. > > > There were no tips that would fit over a tuning pin, so I'll probably > have > > > to have a special one made. So much for bargains. :-( I suspect, after > > > checking the Danair website, that I should have bought on of those! > > > Regards, > > > Joe Garrett > > > ----- Original Message ----- > > > From: "Carl Meyer" <cmpiano@home.com> > > > To: <pianotech@ptg.org> > > > Sent: Sunday, May 06, 2001 8:01 PM > > > Subject: Re: Air Hammer > > > > > > > > > > > > > > Murphy's law strikes again!!! Whenever you buy something, it always > is > > on > > > > sale somewhere else cheaper!!!! > > > > > > > > Oh well. It's only money, > > > > > > > > Carl Meyer > > > > > > > > ----- Original Message ----- > > > > From: Ron Lindquist <ronli@newnorth.net> > > > > To: <pianotech@ptg.org> > > > > Sent: Sunday, May 06, 2001 7:25 AM > > > > Subject: Air Hammer > > > > > > > > > > > > > Harbor Freight Tools has a nice one on sale for $49.95--I got one > when > > > > they > > > > > were $79. > > > > > <harborfreight.com> or 800-423-2567. > > > > > > > > > > > > > > > > > > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC