---------------------- multipart/alternative attachment At 10:37 AM 05/08/2001 -0400, you wrote: >(put a piece of masking tape on the drill to know when to stop). The bit is >usually also the same width as the screw hole. This assures that the screw >hole is centered. I then use a bit the thickness of the inside of the >threads, and drill all the way through the block. Get a tapered bit for a # 20 screw. Much faster. Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@mediaone.net http://www.stanwoodpiano.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/3a/87/e3/af/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC