Hi Rons and Del, I am thinking of something a little different. All the fitting is done out of the case, all holes are drilled out of the case and without the plate then the block and plate are screwed together, the bushings are put in then drilled out from the back side for better alignment for the pin. I will sue one size smaller bit to prevent damage to the block holes. I like the 3 degree angle which is close to my idea of the coil being 1/8" (or less) off the plate and the string coming off the pin is 90 degress to the pin as it rises to the bearing bar. Less an angle is ok but more is not needed. Seven to nine degrees? I think not. Have a good week coming up. Newton mailto:nhunt@optonline.net NetZero Platinum No Banner Ads and Unlimited Access Sign Up Today - Only $9.95 per month! http://www.netzero.net
This PTG archive page provided courtesy of Moy Piano Service, LLC