A.B.Chase soundboard

[Joseph Garrett]

Greg,
IMHO Bleaching not only will compromise the glue jointl, but will attack the
wood itself. It has been my policy, for years, to make it look as nice as
possible, but not to "hide" the repair. I had an instance with a 9' Knabe,
where someone had put a faux finish on both sides of the board, after they
had shimmed. I made the estimate to shim the board, based on the existing
cracks, etc. When the board was scraped, after the shims were inserted, it
revealed all of the many shims previously installed. If I could have seen
those previously installed shims, I would have most definately recommended a
new board to the client. However, since I was already hip deep and
committed, that did not happen. The end product was less than acceptable,
all because someone else covered the work. :-(
Regards,
Joe Garrett
----- Original Message -----
From: "Greg Newell" <gnewell@ameritech.net>
To: "Pianotech forum" <pianotech@ptg.org>; "Master Piano Tech"
<mpt@talklist.com>; "College and University Technicians" <caut@ptg.org>
Sent: Sunday, May 13, 2001 8:30 AM
Subject: A.B.Chase soundboard


> Dear Lists,
>     Now you may think me incredibly slow but I've finally completed
> shimming the soundboard. I've been having trouble conceptualizing how to
> match the shims to the rest of the board. If I bleach the board to even
> it out do I not risk compromising the glue joints? If I take the shading
> approach is there a favorite way you folks out there approach it? I'm
> hoping to play with this today so anything you say can and may be used
> by me soon! Thanks in advance for your help.
>
> Greg
>
> --
> Greg Newell
> Greg's Piano Forté
> 12970 Harlon Ave.
> Lakewood, Ohio 44107
> 216-226-3791
> mailto:gnewell@ameritech.net
>
>