Scaling problem

[Ron Nossaman]

>Regards Roger
>Not in the least bit steamed. This area, I needle the heck out of the
>suckers, hard and deep.

Good. I wasn't trying to make you mad, just picking on you a little. I've
made a few futile attempts at smoothing across the break in the GH1, at
dealer and customer request (and my own curiosity), and the deep needling
did seem to work best. Then, of course, they want you to "finish" the
voicing you started, and make it "right". After all, if a half hour's work
will make x improvement, two hours work should make it four times better.
Right? And it had better stay fixed too. All things considered, I've given
up on any voicing of these with anything but a wire brush. At least I don't
have to waste an appreciable amount of my time and their money to
disappoint a voicing request, but can cheaply disappoint them right away
and get on with it. 


Ron N