Hi Richard. I have had excellent luck using the little moto tool, with the little drum sander and guide when doing hammers that have deep grooves. Once you get a good motion down, its just one quick pass and you are done. I can do a set in as little as twenty minutes. Usually though, I will do a little sanding touchup - but very little once you get a good motion/movement/technique going. This method is Definately ONLY for deep grooves though (you know, like the 1948 Acrosonic that has been played hard but never been reshaped, or the gospel church grand that has had twenty years of HARD pounding). ----- Original Message ----- From: "Tom Driscoll" <tomtuner@mediaone.net> To: <pianotech@ptg.org> Sent: Saturday, May 26, 2001 6:41 PM Subject: Re: Hammer Staples > > > > > I always get accused of using waaaayyyyy to much time reshaping hammers. > > Typically > > > takes me about 4 hours for a really badly worn set. But I end up with a > > really > > > uniform and nice shape..so I guess I gota be happy with that. > > > > > > -- > > > Richard Brekne > > > RPT, N.P.T.F. > > > Bergen, Norway > > > mailto:rbrekne@broadpark.no > > > > > >IMHO, Emory cloth is way too fine for reshaping. If you start with 100 > or 120 grip garnet, and light touch ,you can get that same shape in a half > hour. Then shoeshine method with 220 or 320 paper backed with masking tape > 3 hammers wide can make most hammers shine. Total time 45 minutes max. I'm > sure your end result is great ,but why not pick up the pace with more > abrasion and then take in a movie. Tom Driscoll > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC