I have done this repair a number of times - always on older Steinways. I guess that is part of my justification for using CA - its an older action and, hopefully, the piano will not have that set of wippens for ever. I also remove the wippen from its rail - so quick on a Steinway - so as to not risk getting any on keys, etc. Then applying the glue to the removed tender, and using medium viscosity, pretty well eliminates the risk of getting the nasty glue anywhere you don't want it to go. But you are correct in pointing out that there would always be a risk. Is it not true that the rep spring on C88 is not only adjusted lighter to accomodate the lighter hammer than in the middle of the keyboard, but also the spring wire itself is a heavier guage - or something about the construction of the spring is different - such that simply exchanging wippens and adjusting spring tension would not be ideal? ----- Original Message ----- From: <Wimblees@AOL.COM> To: <pianotech@ptg.org> Sent: Monday, May 28, 2001 7:16 PM Subject: Re: Kahane piano breakdown > In a message dated 5/28/01 4:45:02 PM Central Daylight Time, > mfarrel2@tampabay.rr.com writes: > > << Pull tender off jack, place drop of medium viscosity CA glue on tender tip, > insert and be sure glue is spread around, then a quick shot of kicker - be > sure glue does not migrate to birdseye or elsewhere. >> > > This is the reason I would hesitate to use the CA glue. Yes, it is a good > quick fix, but if you make a mistake, and under the circumstances, it would > be very easy to get nervous and make a mistake, you could render the wippen > useless, and then you would have to switch wippens any way. > > Willem
This PTG archive page provided courtesy of Moy Piano Service, LLC