John, I'll consider buying them all if you promise to donate all the money to GLAAD----Gay and lesbian alliance against defamation--- Tom Driscoll ----- Original Message ----- From: "John M. Formsma" <jformsma@dixie-net.com> To: "PianoTech" <pianotech@ptg.org> Sent: Monday, October 08, 2001 9:14 AM Subject: action parts for sale > List, > > I have a barrel full of hammer butts and wippens for sale. My late father > probably had gotten them from Wurlitzer when the plant in Holly Springs, MS > was shut down. They roughly correspond to the compact wippens/butts in the > supply house catalogs. I have a jpeg available if anyone wants to see them. > There are no backchecks, and I think all the spoons point to the right as > you look at the bridle strap wire, tho I don't know for sure because I've > only seen the ones at the top of the barrel. The dimensions for the wippens > are length 8.6 cm and jack length 5.5 cm. The hammer butts are 5.3 cm from > catcher to the edge of the body of the butt, and 5.4 cm from the butt flange > to the top of the butt. > > There are a bunch of them (several hundred), and I was going to burn them > Saturday just to get them out of the way. However, maybe some of you could > use them for something. There is a little of the green corrosion at the > center pin bushings, typical of parts this age; but nothing that Protek > won't easily remedy. > > I'll take $0.25 per part, separated and bagged in "Walmart" type bag, plus > whatever shipping would be. If you are interested, please respond to the > email address below rather than to the list. > > John M. Formsma > Blue Mountain, MS > PTG Associate, Memphis Chapter > > mailto:jformsma@dixie-net.com >
This PTG archive page provided courtesy of Moy Piano Service, LLC