Yup, it's aluminum. I have one Winter spinet that I service. Stamped Alcoa, and a magnet does not stick to it. I have serviced worse pianos (although this one is not far from the lower end of the spectrum). Terry Farrell ----- Original Message ----- From: "Tom Driscoll" <tomtuner@mediaone.net> To: <pianotech@ptg.org> Sent: Thursday, October 11, 2001 5:50 AM Subject: Re: Trivia , Who had Aluminum plates? > > ----- Original Message ----- > From: "Richard Moody" <remoody@midstatesd.net> > To: <pianotech@ptg.org> > Sent: Wednesday, October 10, 2001 9:18 PM > Subject: Re: Trivia , Who had Aluminum plates? > > > > . Winter's Aluminum plate. > > > > I tuned a Cable (Nelson ?) console that I think had an aluminum plate. > > It was silver colored and had Alcoa stamped on it. I forgot to get the > > serial number and didn't think to try my magnetic picker upper on it. > > Does anyone know of this company used aluminum plates? ---ric > > > ric, > If it said Alcoa it was . I've seen them mostly on Winter's and almost > all were built in 1947-8. Seems to have been a brief experiment. The best > part about these things is how light they are. Like lifting a bureau! > Probably has nothing to do with the plate, but the side -back glue joint > seems to fail on the Winters. > Tom Driscoll >
This PTG archive page provided courtesy of Moy Piano Service, LLC