keytops (Question)

[David Renaud]

This concerns resurfacing the key,
removing wood, decreasing its thickness slightly to
compensate for thicker plastic keytops.
I also use an iron to remove keytops.

                                Cheers
                                Dave Renaud
--- Richard Brekne <rbrekne@broadpark.no> wrote:
> I hear a lot of folks talking about using routing or
> sawing techniques in some
> way for removal of old key tops / fronts in
> preperation for renewal.
> I would like to hear a bit about why you all do this
> instead of using some
> form of heating up the the old keytops so as to
> "peel" off the old top / front
> material.
> thanks
> RicB


_______________________________________________________
Do You Yahoo!?
Get your free @yahoo.ca address at http://mail.yahoo.ca