I am assisting a technician who has replaced the pinblock and board in a Steinway B. The frame has been out of the piano for about 5 months. As we are fitting it back in, it is not at all close to sitting tightly on the front or rear sections of the inner rim. If I clamp the front down tightly, the rear (tail) will raise about three inches (the new pinblock is exactly where the old one was). Is this normal? I was worried that bolting it down that much would stress the plate. Thanks. __________________________________________________ Do you Yahoo!? Yahoo! Mail Plus – Powerful. Affordable. Sign up now. http://mailplus.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC