Chisels, modified

[Joseph Garrett]

1" chisel with a "round" on one end of the cutting edge. I use this for
getting a clean cut on the notch, that bevels up to the termination line.
This has to be done where the flat side of the chisel will be against the
notch side. Hope that clarifies a bit. I got the idea at a Natl. convention.
Don't remember the tech. that offered it. It's been a while and I have a lot
of "Senior Moments". <G> (Don't start Del!)[G]
Regards,
Joe Garrett, RPT, (Oregon)