Greg The Jointech fence that I bought is more ridgid than the Incra that I had. When it is locked down, it provides a stiffer fence for stock to run against. Also, it has a rotating knob on the fence adjustment that allows for very fine settings, to within a thousandth of an inch very easily. This proved to be very helpful when correcting a cut joint, like a dovetail, that turned out too tight or loose. I've use it on my saw table, router table, and can see using it on my band saw. Paul Chick ----- Original Message ----- From: "Greg Newell" <gnewell@ameritech.net> To: <pianotech@ptg.org> Sent: Monday, February 04, 2002 2:48 PM Subject: Re: Jointech vs. Incra > Paul, > Thank you for responding. So few have. Since you have tried and used both > could you expound a bit more about what you liked or disliked about each one? > I'd greatly appreciate it. > > Greg
This PTG archive page provided courtesy of Moy Piano Service, LLC