And, as promised, here is the third address of people who know how to replace ribs on old soundboards..... kobaldpianos@planet.nl. They were one of the first people in Holland to do so. friendly greetings from Antares, Amsterdam, Holland "where music is, no harm can be" visit my website at : http://www.concertpianoservice.nl/ > From: Erwinspiano@AOL.COM > Reply-To: pianotech@ptg.org > Date: Sun, 10 Feb 2002 11:10:16 EST > To: pianotech@ptg.org > Subject: Re: rib replacement > > Antares > > > You know I've heard this idea before and I have no doubts that > I could accomplish this task but no one yet has gone on record as to the > actual step by step procedure to get the old soundboard out of the piano > without sustaianing any damage. > This is the one point I"m 'REAL hung up on. I replace boards all the > time and I have considered this as an option for many stwys that have > uncracked boards but no crown except that , of the many boards I've removed > none came out easily or without major damage. So unless your boards are > falling out of the pianos or there is some secret to do this it then it just > not a feasible alternative. > So I'd like you to ask your friends to post a detailed description of > how they accomplish this one aspect of re-using the old soundboard panel. > Otherwise to me it's just talk and a nice idea. Know what i mean? > >>>>>>>> Regards-----Dale Erwin>>>>>>>>>>>>>>>>>>>. > >>> --- >>> Phillip Ford >>> Piano Service & Restoration >>> 1777 Yosemite Ave - 215 >>> San Francisco, CA 94124 >> >> By 'taking out' the soundboard, >> planing off the old ribs, >> making a mould for the new ribs, >> creating a hollow surface to glue down the ribs, >> shaping the new ribs with a chisel, >> re-varnishing the old soundboard, >> re-stringing, >> >> and thoroughly enjoying the 'new' sound. >> >> I just write this down in a few seconds, but of course the actual work >> takes >> much longer and the final result will only get better after having done >> this >> procedure a lot of times. >> Sometimes it is better to renew the old soundboard as well, depending on >> quality and the physical circumstances of the old board. >> It is not that much more work and if you know what you are doing it might >> even be possible to improve the former situation. >> >> Speed is here of the essence. If one could do this kind of repair in a >> relatively short time (and that is possible) life in a workshop becomes >> even >> more inspiring and rewarding. >> >> I myself do not do this kind of work, I put my energy into regulation, >> tuning and voicing. >> To be able to do this kind of work, the craftsman would have to be born >> with >> a plane in one hand and a chisel in the other. >> When I was born, I had a tuning hammer in one hand and a voicing tool in >> the >> other. >> No wonder my mother used a milk bottle to feed me... (;>)) >> >> >> friendly greetings >> from >> >> Antares, >> >> Amsterdam, Holland >> >> "where music is, no harm can be" >> >> visit my website at : http://www.concertpianoservice.nl/ >> > >
This PTG archive page provided courtesy of Moy Piano Service, LLC