Voicing Tool Recommendation

[larudee@pacbell.net]

Terry,

I use a standard #6 needle, protruding about 3/8", although you can vary it to your preference.  My Dremel came with a collet that zeros out, and I check to make sure there's no waver in the spin.  I spin it at around 10,000-15,000rpm, and it goes in like butter.  Lots of control and less concern about bracing the hammer, because very little force is needed.  I find that even heavy needling goes fast because the one needle penetrates so easily and quickly.  You can also
penetrate deeper than with a stationary needle, which sometimes means fewer strokes.

Hope that helps, and in case Jeannie asks, yes, it's OK to print it.

Paul

Farrell wrote:

> Hi Paul. I've heard of this approach before, but I've not heard many details. Exactly what advantages does this offer, what type(s) of needles do you use, and what techniques do you use (side entry, edge, otherwise, traditional)? Do you basically go at it just the same as with regular tool, only the rotary tool is easier? How do you mount a needle on a Dremel (they seem to only take a certain sized shaft)? Thanks for answers to these and any other question I forgot to ask.
>
> Terry Farrell
>
> ----- Original Message -----
> From: <larudee@pacbell.net>
> To: <pianotech@ptg.org>
> Sent: Wednesday, February 13, 2002 6:17 PM
> Subject: Re: Voicing Tool Recommendation
>
> > A single needle in a rotary tool (e.g.Dremel), cordless or otherwise.
> >
> > Paul Larudee
> >
> > Farrell wrote:
> >
> > > I've been limping along for several years with a Schaff voicing tool that goes in the combination handle. I'm looking to step up. What is your favorite voicing tool and why. Thanks.
> > >
> > > Terry Farrell
> > >
> >
> >