John M. Ross Windsor, Nova Scotia. jrpiano@win.eastlink.ca ----- Original Message ----- From: "Farrell" <mfarrel2@tampabay.rr.com> To: <pianotech@ptg.org> Sent: Sunday, February 17, 2002 11:21 AM If the pin was loose because there are numerous cracks and delaminating occurring in the block, it will likely last until the check clears (OK, maybe a couple weeks longer). That is why I also mentioned the epoxy, to fill those cracks. > Terry Farrell > > ----- Original Message ----- > From: <Tvak@AOL.COM> > To: <pianotech@ptg.org> > Sent: Sunday, February 17, 2002 9:48 AM > Subject: Re: shimmed tuning pins > > > > > > In a message dated 2/16/02 10:39:43 PM, Bigeartb@AOL.COM writes: > > > > << you could use a > > larger sized tuning pin....maybe 4/0. >> > > > > I have to do this on a couple of the strings anyway due to the old string > > breaking at the becket when I turned the pin out. The string segment won't > > come out of the old pin so I'll have to replace it. These pins are 2/0s. > > > > In your opinion is shimming a tuning pin, or replacing it with a larger pin a > > relatively permanent fix? Or will it continue to be a cause for concern? > > > > Tom Sivak > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC