Greetings All. A tip that may help those that rebush keys After steaming out old bushings, the balance rail hole swells to the point that they are far too tight. The following method, I have found to perfectly size the balance rail hole. Rebush keys and leave the cauls in place for 24hrs to size the bushing cloth. Using a new polished balance rail pin that has been polished. Use the pin in a battery operated drill, pump twice through the mortice and balance rail hole from the top side, (this ensures the hole is parallel with the bushing cloth.) just a quick burst of the switch, balance rail hole is perfectly sized. The whole set can be done to perfection in a few minutes. Takes the guess work out of where the friction problem is happening, the hole or the bushing cloth. Hope this will help some. regards Roger regards Roger
This PTG archive page provided courtesy of Moy Piano Service, LLC