Workshop Gallery link change

[Erwinspiano@AOL.COM]

---------------------- multipart/alternative attachment
In a message dated 7/12/2002 6:38:05 PM Pacific Daylight Time, 
RCzekay@AOL.COM writes:


> Subj:Re: Workshop Gallery link change 
> Date:7/12/2002 6:38:05 PM Pacific Daylight Time
> From:<A HREF="mailto:RCzekay@AOL.COM">RCzekay@AOL.COM</A>
> Reply-to:<A HREF="mailto:pianotech@ptg.org">pianotech@ptg.org</A>
> To:<A HREF="mailto:pianotech@ptg.org">pianotech@ptg.org</A>
> Sent from the Internet 
> 
> 
> 
> In a message dated 7/12/02 12:36:05 PM Central Daylight Time, 
> claudia_cimenti@mail.com writes:
>                   

                                  Hi Roy
             Not a thing wrong with the you describe.method. I've used it for 
years with great accuracy. I circle all the holes with a sharp pencil mark 
instead of punch. Whatever works.
 <<<<<<<<<<<Dale Erwin>>>>>.
> 
> 



> 
> >> http://webpages.charter.net/cimenti/workshop
> 
> Hi, I admire your efforts to promote pin block boring. But, what is wrong 
> with the old fashioned way. Fit the block to the plate, and bore all of the 
> screw holes, insert screws, and then with a center punch, mark all of the 
> pin holes. Remove block, and transfer to a good drill press with a 750 RPM 
> setting, with a backing as long as the block, and set at a 5 or 7 degree 
> reverse angle. Much easier, cheaper, and just as accurate than building a 
> complex apparatus to sit on the piano, which in most cases would probably 
> gouge the case.
> 
> Just my thoughts on it. I have done dozens of grand pin block replacements 
> using this method, and none has ever failed.
> 
> Roy Czekay, 
> 
> Milwaukee, WI,
> 
> Not a registered technician, but have been rebuilding pianos for over 30 
> years.


---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/c7/e7/93/07/attachment.htm

---------------------- multipart/alternative attachment--