Large disk sander

[Kdivad@AOL.COM]

In a message dated Fri, 3 May 2002  8:48:58 PM Eastern Daylight Time, "Farrell" <mfarrel2@tampabay.rr.com> writes:

>> With this system I can, to a great degree, control the weight of my hammers, accurately taking the same > amount of material from each.
>
>If you remove the same weight from each hammer, are you aware of the exact weight of each before trimming? Do you not find that you want to add weight sometimes rather than just remove weight?
>
>Terry Farrell
>  
>----- Original Message ----- 
>From: <Kdivad@AOL.COM>
>To: <pianotech@ptg.org>
>Sent: Friday, May 03, 2002 9:40 AM
>Subject: Re: Re: Large disk sander
>
Of course, I never stated I just remove weight, though it is inevitable when shaping hammer tails.  I take measurements and go over the parameters of each action and then decide what I might need to do with the hammers.  Yes, I do add weight if needed but find it is rarely needed.

David Koelzer
DFW