Hi Claudia, 1) Welcome to the list, ...ask away. 1a) There is a turd in our punch bowl. Ignore it. 2) TIGHTEN the screws FIRST! (Before using the compressed air.) Learned that from, uh... Susan Graham, years ago. Saves a lot of headache. Sand, etc, gets under the flanges when you blow out the action. Could call it "air travel". (you'll get that eventually) Sears has a little accessory kit for about 12 bucks that makes any blower-type vacuum almost equal to a small compressor. I use it in the field with a little 2 gal shop vac. 3) Come to Chicago. It's a Smorgasbord, don't leave until you're very full. (and ignore the warnings about my classes) Again, Welcome. SeeYa around, Guy Nichols, RPT Ft. Stinkin' Desert, NM At 10:22 AM 5/5/02 -0700, you wrote: >Hi all, > >First, a couple words to introduce myself: I am a piano technology student >and in the process of restoring my first upright piano. It is a very >educational experience. I have been subscribed to this list for a few days >now, and find it very interesting to read the ongoing discussions. Thank >you for letting me "listen in", even though I am not as experienced yet as >all of you. > >A couple questions: >1. Is it ok on this list for a piano tech newbie to ask questions or is >there a better venue for that? I am not yet a member of the PTG, but plan >on joining very soon. > >2. A quick question on cleaning actions: The old upright I am restoring >has an extremely dirty action. It is very very dusty. How would you go >about cleaning this? I would be interested in hearining how you would go >about doing this with a minimum set of tools ("the hard way"), or in an >established shop. > >Thank you very much in advance for your replies. > >Regards, >/Claudia > "Critics can't even make music by rubbing their back legs together."- Mel Brooks
This PTG archive page provided courtesy of Moy Piano Service, LLC