Pinblocks

[David Love]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
Since Delignit are beech and multilaminate are maple, would you use a =
different size bit on a multilaminate?

David Love
  ----- Original Message -----=20
  From: Jon Page=20
  To: pianotech@ptg.org=20
  Sent: May 05, 2002 12:34 PM
  Subject: Re: Pinblocks


  At 01:47 PM 5/5/2002 -0400, you wrote:

    Hi list,=20
    I forget to ask, what drill bit do you prefer with the deliginit =
block,and the best source for them.I'm using 2/0 pins, 21/2 long.=20
    Thanks,=20
    Hazen Bannister=20

  F =3D .257"   about 900 RPM

  Mic and sort the pins. thinnest in the treble, thickest in the bass


  Regards,


  Jon Page,   piano technician
  Harwich Port, Cape Cod, Mass.
  mailto:jonpage@attbi.com
  ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~=20

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/84/11/e0/38/attachment.htm

---------------------- multipart/alternative attachment--