Pinblocks

[Les Conover]

Hi, all,
    If you use a Vortex chiller (Pianotek) and a slow
feed rate, Delignet can be drilled with an I bit or
even a 7 mm for 2/0 pins.  They will be plenty tight
and you have less wood fiber crushing.  I think and F
bit is far too small.
    Regards, Les Conover
--- Ron Nossaman <RNossaman@KSCABLE.com> wrote:
> 
> >
> > Hi list, 
> > I forget to ask, what drill bit do you prefer with
> the deliginit block,and
> > the best source for them.I'm using 2/0 pins, 21/2
> long. 
> > Thanks, 
> > Hazen Bannister
> 
> 
> I use either 17/64 (0.2657"), or 6.8mm (0.2677"),
> and Denro pins (blued,
> mostly).
> 
> Ron N


__________________________________________________
Do You Yahoo!?
Yahoo! Health - your guide to health and wellness
http://health.yahoo.com