Or go with a sandpaper shim. The increase in torque is very controllable and predictable by using different grits and/or only shimming a portion of the hole. Never jumpy. Excellent tunability/feel. Terry Farrell ----- Original Message ----- From: "Richard Brekne" <Richard.Brekne@grieg.uib.no> To: "PTG" <pianotech@ptg.org> Sent: Wednesday, October 02, 2002 5:50 PM Subject: Loose Tuning Pins Solution > Ran into a temp quick fix for the classic loose tuning pin > syndrom today. Completely non invasive as well. Take a piece > of backcheck leather about the length of the tuning pin, cut > it circa 2 mm wide, and insert it into the hole so that > about 3 mm is sticking out the end of the hole. Bang the pin > back in whilst holding the end with a pair of needle nose. > > Tightens them suckers right up without the dope. Seems to > last a long time too. Causes the pins to jump a bit... but > hey... thats the least of your problems ! > > Cheers > > RicB > > -- > Richard Brekne > RPT, N.P.T.F. > UiB, Bergen, Norway > mailto:rbrekne@broadpark.no > http://home.broadpark.no/~rbrekne/ricmain.html > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC