Hammer Spring Rail Replacement

[Gordon Holley]

Hi Joe, yes the screws were a bear to get out, but I finally got them 
out.  Thanks for the suggestion on the replacement machine screws, 
I've take a look at that also.
Regards, Gordon Holley

On 15 Oct 2002 at 11:16, Joseph Garrett wrote:

> I strongly suggest that, when replacing the springs, you also replace those
> impossible to get at screws with 1/4 - 20 machine screws w/the brackets
> tapped accordingly. If you do that, then you have a nice option of placing
> shims under the head of the machine screw to correct the inevitable warpage
> of the rail.
> Joe Garrett, RPT, (Oregon)
> 
> Been There, Didn't Like It, So I'm Here To Stay! [G}
> 
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives