Hi. Good point, that is necessary on many (and not done most of the time, while it is fast and easy to drill the plate). I.O > > >I have never done one of these before, but I fear that if > you drill the > >hole in the middle of the plate hole you will end up with > the tuning pin > >riding the plate on the rear side of the hole. > > > >Terry Farrell > > Part of the job is drilling out the plate webbing holes big > enough that > this won't happen. If you aren't using a low density block > that won't > support a tuning pin without having the pin riding the > plate, the hole is > too small anyway. > > Ron N > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC