Where do they go.......if you bottom them? Terry Farrell ----- Original Message ----- From: "Ron Nossaman" <RNossaman@cox.net> To: <ilvey@sbcglobal.net>; "Pianotech" <pianotech@ptg.org> Sent: Sunday, October 27, 2002 7:43 PM Subject: Re: Bridge pin bit size -Phil Ford > > >Ron, > > > >Excuse my inexperience...it has been a long time since I put in bridge pins. > >When last did that (26 years ago) we used nails of the appropriate size > >(pointed of course), > >cut them off over long and drove them in. Finishing off by filing. If > >you aren't > >going to file to even out bridge pin height, does that mean that every > >hole is exactly > >the same depth? That a pin won't go in little farther than its neighbor? > > > >David I. > > David, > I drill just a little deeper than necessary and drive to finish height. > Contrary to nearly universal belief, bridge pins not only don't need to be > bottomed out in the hole, they won't stay there if you do bottom them. > > Ron N > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC