separated pin block

[jolly roger]

---------------------- multipart/alternative attachment
At 09:53 PM 9/6/02 -0400, you wrote:
>Sounds like a good way to make this repair real neat. I have bent a couple 
>BIG "C" clamps doing this repair. I have found pipe clamps to work better 
>for me. But hey, that's just me!  ;-)
>
>Terry Farrell
Hi Terry ,
                  I have 6 really heavy duty German made C clamps, with 
lots of torque.
If  the lag screws go into spacer blocks I dowel the spacers to the back 
post  with 1/2" maple dowel.   Run the dowel through the belt sander to put 
a small flat down  it.  A liberal amount of epoxy down the hole. Insert the 
dowel rod, twisting it as you go. This will allow a space to get the excess 
epoxy to get out.  It will make the back support nice and solid.
Roger

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/cc/ff/9e/a7/attachment.htm

---------------------- multipart/alternative attachment--