PinBlock too low

[gordon stelter]

Could you let the tension off the strings, loosen the
plate and raise it enough to slide some shims under
the sides of the block? Might just be glides, though,
plenty "tooners" don't know what to do with them.
     Thump
--- Mike and Jane Spalding <mjbkspal@execpc.com>
wrote:
> Joe,
> 
> Yes I agree.  I have advised the customer to demand
> solution or payment from the rebuilder.  she is
> understandably reluctant to put the piano back in
> the hands of the guy who messed it  up in the first
> place, but I do hope she gets some money out of him.
> 
> regards,
> 
> Mike
> 
> ----- Original Message ----- 
> From: Joseph Garrett <joegarrett@earthlink.net>
> To: <pianotech@ptg.org>
> Sent: Thursday, September 12, 2002 8:40 PM
> Subject: PinBlock too low
> 
> 
> > Let's face it, the "rebuilder", (term used VERY
> loosely), screwed up. If I
> > were the customer, I would damned sure make him do
> it over right. OR have
> > him pay for someone else to do it right.
> > Just my nickle's worth. (Pennies are on their way
> out, :-( )
> > Best Regards,
> > Joe Garrett, RPT, (Oregon)
> > 
> > Been There, Didn't Like It, So I'm Here To Stay!
> [G}
> > 
> > _______________________________________________
> > pianotech list info:
> https://www.moypiano.com/resources/#archives
> > 
> 
> _______________________________________________
> pianotech list info:
https://www.moypiano.com/resources/#archives


__________________________________________________
Do you Yahoo!?
Yahoo! News - Today's headlines
http://news.yahoo.com