This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi David, The new design features are the finger holds and reduced length making = the tool easier touse especially in the upright action. It is also made on a new mill that holds the depth of the arc to .003 to = .005 of the desired depth as well as centering the holes better to allow = shortening the tool as much as possible. The side notches are for the thumb and second finger and the notch that = is on top is where the first finger holds the tool. Much easier to use in tight places. Joe Goss imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: David Love=20 To: Pianotech=20 Sent: Saturday, September 28, 2002 7:17 PM Subject: Re: Mvc-020s.jpg Joe: How is this different from the one I have--which works very well, by = the way. =20 David Love ----- Original Message -----=20 From: Joe And Penny Goss=20 To: Pianotech@ptg.org ; caut@ptg.org=20 Sent: September 28, 2002 5:50 PM Subject: Mvc-020s.jpg Hi all, Only open if you want to see the new design of the fitting block. = The new design is now on my web site but is available in quanities now. Mvc-020s.jpg=20 -------------------------------------------------------------------------= --- _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/bd/7f/3d/a3/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC