This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi Jon, Ever see my tool for traveling hammers? And the one that is with it for = shoeshining those hammers gang style? Joe Goss imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Jon Page=20 To: Pianotech=20 Sent: Sunday, September 29, 2002 12:18 PM Subject: Re: Hang'n dem Hammers At 02:10 PM 9/29/2002 -0400, you wrote:<snip> As far as traveling is concerned, you should do that after hanging = any way. The hammers give you a much better guide.=20 Wim=20 I travel new shanks before hanging the hammers because if you hang the = hammer straight and then have to shim a travelling shank, the hammer is not longer straight. Then you will either have to remove = the hammer and reglue or burn-in if slightly off. Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@attbi.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/0e/35/a7/70/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC