At 10:13 PM -0700 8/21/03, David Love wrote:
>I have found it awkward to measure the center pin height as well.
From the world of machinist tools, a surface gage
(http://jlindustrial.com/catalog/product.jsp?id=MAY-55520A) or a
height gage
(http://jlindustrial.com/catalog/product.jsp?id=PDR-10413A).
Bill Ballard RPT
NH Chapter, P.T.G.
"I gotta go ta woik...."
...........Ian Shoales, Duck's Breath Mystery Theater
+++++++++++++++++++++
This PTG archive page provided courtesy of Moy Piano Service, LLC