Big Bushings/Ron Nossaman

[Ron Nossaman]

>Joe
>After you finished with step 2, place a scrap piece under your stock and
>clamp it to the table.  Now redrill one pin hole throught the stock and
>partly into the scrap.  Remove the stock, install and glue a short dowel of
>appropriate size into the scrap. It is an easy matter to center the pin
>holes under the plug cutter by placing the stock onto the index pin.
>Continue the process as described.
>
>Paul C

Joe, Paul,
Thanks for the information and suggestions. I'll give this a try on the 
next one.

Ron N