At 12:26 PM -0500 8/31/03, Richard Oliver Snelson wrote: >Put them in before spraying the >plate to avoid ruining the finish. (Better yet brush the walls of the >holes with the epoxy.) Better yet, glue the bushings in the plate holes (just before final assembly). One could do this in or out of the piano, but in either case there should be a firm surface underneath the plate web (in the piano, the installed block, outside, a piece of scrap plywood), separated by wax paper. Not that I've ever been in to position of having to do something like this.... Bill Ballard RPT NH Chapter, P.T.G. "May you work on interesting pianos." ...........Ancient Chinese Proverb +++++++++++++++++++++
This PTG archive page provided courtesy of Moy Piano Service, LLC