So, then, would the ideal drilling/pinning technique
be Denro pins in a Delignit ( Or Farrelwood )block,
drilled with the two bit method and spot chilled? But
turned in, or driven with air hammer? And what is this
two-bit method again, if you don't mind?
Thump
--- Ron Nossaman <RNossaman@cox.net> wrote:
>
> >FWIW, I have used the Diamond. I bought them
> BECAUSE they were more
> >expensive (the standard theory being that I will
> screw up enough, might as
> >well use the best materials - that might make up
> for some of my work). Not
> >knowing which pins where like what, I was just
> hoping they were a little
> >bit better in some way. I found that they varied in
> diameter over a few
__________________________________________________
Do you Yahoo!?
Yahoo! Tax Center - forms, calculators, tips, more
http://taxes.yahoo.com/
This PTG archive page provided courtesy of Moy Piano Service, LLC