Upright Stringing - Pressure Bar

[Isaac OLEG]

of course you are right.

If you can find a pneumatic racket wrench you can use it to coil the
tuning pins in the block (as done in some factories) before inserting
them with the palm nailer.

Best

Isaac OLEG

Entretien et réparation de pianos.

PianoTech
17 rue de Choisy
94400 VITRY sur SEINE
FRANCE
tel : 033 01 47 18 06 98
fax : 033 01 47 18 06 90
cell: 06 60 42 58 77

> -----Message d'origine-----
> De : pianotech-bounces@ptg.org
> [mailto:pianotech-bounces@ptg.org]De la
> part de Farrell
> Envoyé : vendredi 13 juin 2003 13:24
> À : pianotech@ptg.org
> Objet : Upright Stringing - Pressure Bar
>
>
> I will be stringing an upright in the next few days. I have
> the pressure bars off. Seems to me that it would be a lot
> easier to string up the plain wire section, leaving the
> tension fairly loose, and installing the pressure bars
> after the strings are on - would be much less restrictive
> than dealing with the short segment of wire protruding from
> under the bars if they were installed before hand. What do
> others do? Which way works best?
>
> Terry Farrell
>
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives
>