Richard, I wasn't aware that Baldwin had ever had more than one size of the Accu-Just hitch pins! Am I wrong? Avery At 01:37 PM 06/26/03 -0500, you wrote: >I was contacted by Baldwin today by email. Thomas Malone informed me on >the stringing scheme for the plain strings, but neglected to tell me about >the bearing settings, so I have to get back to him on than. Mapes can make >the strings, but need to know if the hitch pins are the 1/4" variety, so I >have to make another trip back. I have to go back anyway, as I have to >pull a tuning pin to measure it also. Thanks again for all your help. > >Richard >>-----Original Message----- >>From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On >>Behalf Of Kevin E. Ramsey >>Sent: Tuesday, June 24, 2003 9:15 PM >>To: Pianotech >>Subject: Re: Accu-Just Hitch Pins >> >>Hi, Richard. Let us know if and when you get contacted by Baldwin, will >>you please? >>Kevin >>>----- Original Message ----- >>>From: <mailto:rstrang@pa.inter.net>Richard Strang >>>To: <mailto:pianotech@ptg.org>'Pianotech' >>>Sent: Tuesday, June 24, 2003 3:39 PM >>>Subject: RE: Accu-Just Hitch Pins >>> >>>My major problem is I'm alone here in Panama. There are no other >>>technicians around that could possibly help me in a dream. If this >>>Baldwin is so particular as to how the string is put around the hitch >>>pin, God help the ambassador's piano if she gives the job to someone >>>other than me. I will have to buy a down bearing gauge and learn how to >>>use it. I have already sent an email to Baldwin to get information as to >>>the stinging scheme and the down bearing measurements. Thanks for the input. >>> >>>Richard >>>
This PTG archive page provided courtesy of Moy Piano Service, LLC