Drying down a panel

[Delwin D Fandrich]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
Re: Drying down a panel
  ----- Original Message -----=20
  From: David Love=20
  To: Pianotech=20
  Sent: November 06, 2003 6:10 AM
  Subject: Re: Drying down a panel



  Thanks Ron, but I'm not as young as you think.

  David Love
  davidlovepianos@earthlink.net



In that case, and depending on the volume of work you intend to do, you =
can build a simple box large enough to accommodate the largest =
soundboard you expect to be working on. Something on the order of 8' x =
5' x 1' should do the trick. Use flakeboard or something similarly =
cheap. It's easiest to use the ends as doors but much more convenient in =
use to make the doors on the front. (Put a 1' strip across the bottom =
and split a 4' x 8' panel into two 4' x 4' pieces. Use "piano hinges" at =
each end. Don't worry about making it completely airtight -- you'll want =
a bit of air exchange going on. Put in a couple of posts and braces to =
keep the soundboard panel(s) up off the floor and spaced away from the =
walls. Down in the lower right hand corner put a small oil-filled =
electric heater. This should be a fairly high quality device with a =
decent thermostat and a low-wattage setting (300 to 600 watts will be =
adequate). Above (or beside) this place a small, non-oscillating =
electric fan to keep the air blowing gently around.

Go back to the archives and find Ron's description of his handy wood =
moisture content meter and make one. Set it up somewhere toward the =
middle or top.=20

Put the panel -- more or less centered -- in the box. If you're drying =
more than one panel use wood stickers to keep them separated. Turn on =
the heater and the fan. Check the wood moisture content meter daily. =
Once you have everything down to the MC you want, turn down the heat and =
leave it all to stabilize for a few days.

Del
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/50/48/09/bd/attachment.htm

---------------------- multipart/alternative attachment--