David said: ".
3 to 7 o'clock??? If 12 is the strike point, then 3:00 is at the widest
area of the shoulder, and the moulding would be from about 5:30 to 6:30, or
even from 5:00 to 7:00 -- all wood!"
--David Nereson, RPT
David et al,
Oops! Sorry about that! I meant 3 o'clock/9 o'clock! However, and no matter
if it's 11 o'clock/1 o'clock, the fact remains, if you are supposed to
"Poke" the crap out of a hammer BEFORE installing it, it's a poorly made
hammer and should be sent to the circular file, IMVSO!
Regards,
Joe Garrett, RPT, (Oregon)
Captain, Tool Police
Squares Are I
This PTG archive page provided courtesy of Moy Piano Service, LLC