Bob, When I was rebuilding I made it SOP to always ream / burnish and repin the shanks. Get a simple spring type gram gauge from a supply house, and pin the full set to 4 - 5 grams friction, measured at the screw holes. That should be a good friction level for 60% humidity. Don Mannino RPT At 03:59 PM 8/23/2004, you wrote: >List, > >I was preparing a new set of shanks and flanges for an >action rebuild (a recital hall piano)and found that >the pinning maybe too loose. Many of them will swing >8-10 times before coming to a stop; some will swing 11 >- 12 and a few 7 times. These are high quality parts >from a reputable manufacturer. The humidity in my >shop is in the mid 50's. When winter comes and the >humidity in the recital hall drops way down won't >these be to loose? I was looking for about 3-5 swings >in the bass graduating up to about 7 max. in the >treble. > >I am facing a deadline and may need to get another set >sent if the manufacturer agrees which will cost me at >least 2 days. > >Would you repin, reorder or what? > >Bob Hull > > > > >__________________________________________________ >Do You Yahoo!? >Tired of spam? Yahoo! Mail has the best spam protection around >http://mail.yahoo.com >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC