Hey Terry, I bought one of those tubes so long ago, I can't remember where I got it--must have been at a convention. You're talking about the one that you load with backrail cloth, right? I use it and like it. It sure beats the hard shoe-shining type work (IMO), but I still end up wiping off the pins with a cloth and the very end of the process. I keep the dirty (protective) punchings in a zip lock bag, so I don't have to use new ones each time. (I still apply the Flitz with my fingers!) Barbara Richmond, RPT ----- Original Message ----- From: "Farrell" <mfarrel2@tampabay.rr.com> To: "Pianotech" <pianotech@ptg.org> Sent: Friday, August 27, 2004 6:03 AM Subject: Key Pin Polishing, Was: a Teflon post) > I also Flitz keypins. Although I manage to keep my fingers out of the direct > fray! > > Has anyone any experience with the little polishing tubes that Jim Coleman > Jr. sells? I made a couple of similar designs a while back and was not happy > with the performance, but perhaps it was my bad design. If they work, it > sure would be easier and faster than shoeshining (and boy, I make a mess of > the keyframe when shoeshining). > > Terry Farrell > > > > When I was Flitzing the keypins, in probably a very archaic method, I used > > my fingers to apply the Flitz, removed it with cloth and then shoeshined > > with a strip of rag. Yes, labor intensive... > > > > David I. > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC