Pinning on new flanges

[Richard Brekne]

Hi Dean.

I just use the usual burnishing tool... put a little bit on the tip and 
work it into the bushing... then burnish as usual.  Not very time 
consuming either.

Cheers
RicB

Dean May wrote:

>>>When repining as I so often do,  I ream out a little bit in attempt to
>>>      
>>>
>minimize graphite content, and work as much teflon powder into the
>bushing as I can.
>
>
>
>Ric,
>
>Could you give us your procedure for how you "work" the Teflon powder into
>the felt?
>
>  
>