---------------------- multipart/alternative attachment
List
Nothing is more embarrassing than not being able to get the fallboard and
cheekblocks out of the piano when you want to work on an action problem. This
happened to me yesterday with a Howard grand, circa 1920s. Fallboard did not
lift out. Cheekblocks had screws from the top, but would not come out when
the screws were removed. There was no screw from the side (horizontally
accessible below the key). Removed a screw from below, but no luck: it was there
to hold the leg on. I think that perhaps there was another screw behind the
fallboard but since I couldn't get the fallboard out either, I'm not sure.
Any ideas on how to open this Howard grand up?
I have listed below the different configurations of cheekblock/fallboard
designs that I am familiar with. Could anyone add to this list? Perhaps the
combined experience of the list will help some of us avoid lost time and utter
humiliation in front of our clients!
This is what I've come across so far:
CHEEKBLOCKS
Screwed in from below
Screwed in from above (often under a rubber button)
Screwed in from the side (access below key)
Attached to fallboard, screwed in from below
FALLBOARDS
Lifts out
Screwed in with tiny screws accessible and viewable from the front
Screwed in on the metal hinge thingee, accessible if pulled forward
at a 45 degree angle and unscrewed from the side
Attached to cheekblocks: unscrew cheekblocks and remove fallboard
and cheekblocks
together (ala Steinway)
Unfortunately for me the Howard grand fits into none of these categories.
HELP!
Tom Sivak
Chicago Chapter PTG
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/f1/b7/77/65/attachment.htm
---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC