pitchlock followup 1

[jason kanter]

Definitely try different positionings for the coupler. It seems obvious that
if the coupler is in, say, somewhere in the middle of the speaking length,
it will impede vibrations and be a source of interference depending on where
it sits (right on a node, etc.) Likewise if it is right at a termination, it
is bound to interfere with the behavior at the termination point.
||  |||  ||  |||  ||  |||  ||  |||  ||  |||  ||  |||  ||  |||  ||  |||
jason kanter . piano tuning/regulation/repair
bellevue, wa . 425 562 4127 . cell 425 831 1561
orcas island . 360 376 2799
----- Original Message ----- 
From: "Cy Shuster" <741662027@theshusters.org>
To: "Pianotech" <pianotech@ptg.org>
Sent: Tuesday, June 08, 2004 12:01 PM
Subject: Re: pitchlock followup 1


> How true! <G>
>
> Just as an experiment, the first thing I'd try is to couple strings 2 & 3,
> and then add a coupler on 1 & 2.  Would that dampen #2 too much?  What if
> you put the other coupler near the hitch pin?
>
> I know -- I should follow the protocol, and just try it, and report back
> when I'm done...  Maybe I'll grab some in Nashville.
>
> --Cy Shuster--
> Bluefield, WV
>
> ----- Original Message ----- 
> From: "Ron Nossaman" <rnossaman@cox.net>
> To: "Pianotech" <pianotech@ptg.org>
> Sent: Tuesday, June 08, 2004 2:29 PM
> Subject: Re: pitchlock followup 1
>
>
> >
> > >Cy,
> > >Not saying that it can not be done. I just wonder with all the
> differences
> > >in notching, if one coupler could ever be made to cover all the varying
> > >different situations.
> > >Joe Goss
> >
> >
> > If there is, I have a suggestion what to call it - a bridge...
> >
> >
> > <G>
> >
> > Ron N
>
>
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives
>