Relocating Knuckles

[Erwinspiano@aol.com]

---------------------- multipart/alternative attachment
In a message dated 5/21/2004 1:12:53 AM Pacific Standard Time, 
sec@overspianos.com.au writes:
Hi Dale,

Just to add to Joe's comments, we use a tungsten carbide slotting 
cutter in our small milling machine at 2000  RPM. Using the X, Y and 
Z slides on the milling machine it is possible to do a very nice job 
with an appropriate jig to hold the shank in an indexed position.

Best,
Ron O.
     Hi Ron
   Thanks. Came up for air I see. Sounds like a great set up. Can I borrow it?
   Dale

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/e1/f5/c4/08/attachment.htm

---------------------- multipart/alternative attachment--