About Checking

[tom driscoll]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment

  ----- Subject: Re: About Checking


  William asked: "Also tried varying the backcheck height, which showed =
no noticeable
  improvement with either higher or lower backchecks.  Also tried =
changing the
  backcheck angle - again no improvement one way or the other, hammers =
simply
  will not check on soft blows."

  William R. Monroe


  William,
  If you've tried all of that, then it has to be something you didn't =
try.<G> Have you checked to see if the keyframe is bedded properly? I've =
known that to mess up checking.
  Best Regards,


  Joe Garrett, R.P.T.

      William,
      I'm late to this thread ,so excuse me if this is redundant, but =
worn balance rail holes--I.E. pulley keys--can result in poor checking.
      Tom Driscoll
      
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/fc/b7/5f/b9/attachment.htm

---------------------- multipart/alternative attachment--