This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment The tool is wide enough to do 88 and sometimes 85 depending on the = cheeks you have. This tool is intended to do the full keyboard, not a touch up tool. For touch up I use the spacer ( 11" long ) of my voicing tray. BTW do you also use the heavy wire tool to lift a short section of keys = when inserting the split punchings? Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Quentin Codevelle=20 To: pianotech=20 Sent: Monday, November 22, 2004 9:09 AM Subject: (no subject) Hey Joe (ok, this was an easy joke too make... ;-) Are the photos on your website reflecting the exact size of the = levelling device, or is it just for presentation? Because on the photos, the levelling is done on a sample of a keyboard = (probably 2 octaves). How long is the levelling edge? Can you level the entire keyboard = without moving the edge from one section of the keyboard to another? BTW, you were talking about back check leads. According to you, is it better to regulate the keyboard height with = the action screwed on the keyboard, and with inserting cut(with = scissors)-balance rail punchings? When I have to do an entire levelling on a grand, I put leads on the = back checks and regulate the keyboard in the piano, with my Yamaha = straight edge.=20 But when there are only a few modifications to make to the levelling, = I simply cut one side of the punchings I have to add with scissors, and = insert it while lifting the keys and the felt punching at the same time. Quentin ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/68/2d/c2/62/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC