---------------------- multipart/alternative attachment Ah, yes, Joe. There is more to report on this but whether I create a living sculpture out of epoxy or actually cut a new bridge, there is another nightmare looming ... This is going to totally screw up hammer and damper alignment for 26 notes! I don't even know if the hammers will fit and/or if I'll have to redrill those rails, too. Alan Barnard Salem, Missouri ----- Original Message ----- From: Joe Garrett To: pianotech Sent: 08/01/2005 10:29:52 PM Subject: Re: Bridge Disaster- - Should be Bridge From Hell!! Holy Wood Workers Batman! (My usual "Yikes" doesn't do it justice!) That's one of the worst I've seen! My first thought was: "Well, that's what ya get for buying a Cheap POS"! "Toss it in the nearest landfill!" However, there is a solution: Break out the Epoxy and Bond all of that "Select Hardwood" together. Then, plug most of the holes; lay out a proper pin spacing and redrill the speaking length pin holes; insert new pins and yer done. I've done it. It's a lot of work, but it's doable. Sympathy, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/28/d2/67/ba/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC