One of the problems I have with these things is that the compressors make so much damn noise. Does anyone build cabinet for these things in which you can keep them a bit quieter and then have a hose running out to hook up your various pneumatic tools? David Love davidlovepianos@comcast.net -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Jeannie Grassi Sent: Wednesday, August 17, 2005 8:54 PM To: 'Pianotech' Subject: RE: Danair Pneumatic palmnailer for driving tuning pins Hi David, I went through the same process a while ago. I ended up getting a Senco palm nailer for a very affordable price. I've used it with no other head than the 1/4 in. one that came with it and it worked fine. I wasn't sure it would work because of other people's concerns, but I didn't run into any problems.....just getting used to it's power and being careful not to drive the pins all the way through the block!! Maybe I was just lucky. jeannie Jeannie Grassi, RPT Assistant Editor, Piano Technicians Journal mailto:jcgrassi@earthlink.net -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of David Love Sent: Wednesday, August 17, 2005 8:45 PM To: 'Pianotech' Subject: Danair Pneumatic palmnailer for driving tuning pins I was looking through the archives interested in perhaps buying one of these for stringing and was wondering if there are other models than the Danair model that people like, what size head diameter works best and whether or not you need to do anything to protect the top of the pin? Thanks David Love davidlovepianos@comcast.net _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC