Alan,
What kind of glue did you use to secure the backcheck wire into
the wippen?
Greg Newell
At 12:57 PM 3/21/2005, you wrote:
>Upright 1890 Kranich & Bach, in very good condition after much work, had a
>treble hammer that bobbled a bit.
>
>Checked regulation points, all similar to its neighbors which worked fine.
>Held the left pedal down a bit; didn't help. Tried the key with fewer
>front rail punchings; no help.
>
>Realized the hammer wasn't checking at all. Tried adjusting backcheck;
>hammer would not check in any position! Made double-sure backcheck was
>aligned squarely to catcher and that felt and leather were good--same as
>neighboring notes.
>
>Hmmm.
>
>Perfectly squaring and aligning the backcheck was what led to the proper
>diagnosis (hint) but did not improve checking at all. Repair took a about
>30 seconds and did not require turning any screws or any regulating. In
>fact, I used no tools at all. Hammer now checks perfectly, wherever I want
>to adjust it.
>
>Age of piano is a hint, although the problem had nothing to do with the
>brand of the piano or it's action design which is very "modern," at least
>as far as wippens, hammers, and butts go (but don't get me started on it's
>rocker capstans and short, secondary stickers that are attached with
>screws to the capstans). The point is, this problem could occur in ANY
>upright but is more likely in an old one.
>
>No purchase required to enter.
>
>Alan R. Barnard
>Sendin' Out Stumpers From Salem, MO
>
>
>--
>No virus found in this outgoing message.
>Checked by AVG Anti-Virus.
>Version: 7.0.308 / Virus Database: 266.7.4 - Release Date: 03/18/2005
Greg Newell
Greg's piano Forté
mailto:gnewell@ameritech.net
This PTG archive page provided courtesy of Moy Piano Service, LLC